Liaoyang valve sealing requirements

 

The sealing performance of the valve refers to the ability of each sealing part of the valve to prevent the leakage of the medium. It is the most important technical performance index of the valve. There are three sealing positions of the valve: the contact between the opening and closing parts and the two sealing surfaces of the valve seat; the matching place between the packing and the valve stem and the stuffing box; the connection between the valve body and the valve cover. The previous leakage is called internal leakage, which is commonly referred to as lax closure, which will affect the ability of the valve to cut off the medium. For shut-off valves, internal leakage is not allowed. The latter two leaks are called external leakage, that is, the medium leaks from the inside of the valve to the outside of the valve. Leakage can cause material loss, pollute the environment, and cause accidents in severe cases. For flammable, explosive, toxic or radioactive media, leakage is not allowed, so the valve must have reliable sealing performance.

 

Daily maintenance of Liaoyang valve

 

1. Pay attention to the storage environment of the valve. It should be stored in a dry and ventilated room, and both ends of the passage should be blocked.

 

2. The valve should be checked regularly, and the dirt on it should be removed, and anti-rust oil should be applied to its surface.

 

3. The valve after installation and application should be checked and repaired regularly to ensure its normal operation.

 

4. Check whether the sealing surface of the valve is worn or not, and repair or replace it according to the situation.

 

5. Check the wear of the trapezoidal thread of the valve stem and the valve stem nut, whether the packing is out of date and invalid, etc., and replace it if necessary.

 

6. The sealing performance of the valve should be tested to ensure its performance.

 

7. The valve in operation should be intact, the bolts on the flange and bracket are complete, the threads are not damaged, and there is no looseness.

 

8. If the handwheel is lost, it should be equipped in time and cannot be replaced with an adjustable wrench.

 

9. The packing gland is not allowed to be skewed or have no pre-tightening gap.

 

10. If the valve is used in a harsh environment and is easily contaminated by rain, snow, dust, sand and other dirt, a protective cover should be installed for the valve stem.

 

11. The ruler on the valve should be complete, accurate and clear, and the valve should be sealed and capped.

 

12. There should be no dents or cracks in the insulation jacket.

 

13. Avoid knocking on the valve during operation, or supporting heavy objects.